Description
While beeglitch is active, it is possible to set up several batspears, then warp between them. By setting up a Batspear linkage in one room (Room A), then entering another room and pinning a Batspear there (Room B), it is possible to set up a controllable warp. Move far enough away that both rooms unload, then start moving back. The room Slugcat is in when Room B is loaded back in becomes the destination room. When Room A is loaded, the warp will trigger. If Slugcat was in a pipe when Room B loaded in, it will warp to that pipe entrance. If Slugcat was not in a pipe, it will instead warp to the pinned Batspear’s location in the destination room. The camera will not warp, but you can open the map to see where you are.
Notes
Instead of pinning a wall, creatures can be pinned instead. This has a similar effect, but Slugcat will instead be warped to the creature’s position. This can be used to reach areas not normally accessible with pinned spears, though it is difficult to determine when and where a creature unloads.